Toolworker's Recent Activity

  1. Toolworker replied to the thread Bug & Features Feedback.

    While you're asking about colors, Domenick - I am happy to be identified as a subscriber, but would prefer a more dignified color than...

    Jul 5, 2020 at 1:09 PM
  2. Toolworker replied to the thread 12V battery.

    I believe this only happens when plugged into an EVSE. Were you plugged in? A workaround could be to only plug in when necessary. I...

    Jul 4, 2020 at 12:47 PM
  3. Toolworker replied to the thread 12V battery.

    21:00. It can be seen on the 07/01 graph here. Not quite. I've seen problems with two EVSEs and three circuits. Only the 240v...

    Jul 3, 2020 at 6:45 PM
  4. Toolworker replied to the thread 12V battery.

    I can confirm that. I just ran Utility mode for over an hour to recharge my once again dead 12v. battery. (And Bluelink emailed me an...

    Jul 3, 2020 at 6:27 PM
  5. Toolworker replied to the thread Seeing reports of a Kona Recall in form of Software Update.

    Hey, me too. The positive cap was up and the negative one was missing. But it was my own fault. I messed up when reinstalling my BM2...

    Jul 3, 2020 at 6:00 PM
  6. Toolworker attached a file to the thread 12V battery.

    [ATTACH] After the BMS update, it appears to check the voltage every four hours. If it's above some level - looks like around 12.6v -...

    12v discharge 6-30 - 7-02.jpg 12v discharge 7-03s.jpg Jul 3, 2020 at 5:48 PM
  7. Toolworker replied to the thread Kona is Good but....

    Yes. Hybrid and EV system is warranteed to 10 years or 100K miles and 70% battery capacity. The powertrain has the same limits for the...

    Jul 1, 2020 at 4:52 PM
  8. Toolworker replied to the thread 14.0 Multimedia Update Prohibits Reordering Presets?.

    info@mapnsoft.com

    Jul 1, 2020 at 10:37 AM
  9. Toolworker replied to the thread Kona is Good but....

    I live on a twisty road. The first EV I test drove when starting to shop last fall was the Tesla. The accelerator was fun - as it is on...

    Jun 30, 2020 at 10:59 PM